All orders Departing from Florida, U.S.A.  

Power Wire/Adapters

Grid List

Set Descending Direction

1-10 of 45

Page:
  1. 1
  2. 2
  3. 3
  4. 4
  5. 5
  1. Regular Price:

    $1.99
    View Details
  2. Regular Price:

    $0.99

    The new XT60+ is here!  With "snap on" insulating end caps to provide the best polarity insulation for your soldered connections, these are sure to become the most popular battery connector for hobbyists.

    The basis of the original robust XT60 design has been retained and the connector is compatible with the original XT60, but now thanks to the snap on end cap there is no need to use heatshrink and the ridged edges on the end cap provide extra grip when pulling the male and female connectors apart.

    Initial assembly requires a little force to clamp the end cap in place but please note that the end cap is hard to disassemble once it has been installed.  Should you wish to remove the end cap  you will have to "break it" with both hands to get it to release.  

    Specs:

    Material: Gold-plated copper
    External Material: Nylon/PA
    Max. RC/MC: 60A/100A
    Weight: 7.72g
    Pulling Force/600: 3kg
    Temperature Resistance: -20°C~120°C
    Recommended Cable Spec.: 12AWG
    Recommended Soldering Spec.: 480°C/4S

    Includes:
    1 sets of male and female plugs

    Learn More
  3. Regular Price:

    $2.50

    Now in a mini designed for mini Quads!! In our testing this unit will save your camera and VTX in a system with active braking ESC, that can back-feed Spikes into the system. If you have room and we highly recommend the normal units for maximum protection.

    Base off the  " "L-C Power Filter-1.7A"  this filter will Clean up and dirty power supply. This is a compact and effective LC filter designed to clean a noisy DC power supply. Perfect for sensitive FPV- and RC-components in a single battery setup. The filter has properties to reduce the effects of interference radiated through the air and noise conducted via the power wires. One advantage of this filter is that both the negative and positive leads are filtered (common mode).

    Suitable for setups up to 16V and maximum 3A  load. Problems often occur on sensitive FPV video systems when long power leads (7cm+) are used, limited space for wiring, improperly filtered transmitters, noise from speed controller or switch mode DC-DC voltage converter, or most commonly a shared battery is used to minimize weight. The interference can result in video lines, banding, random drop-outs, and reduced transmission range. A low-pass LC-filter will help attenuation most of the high frequency power supply noise and interference.Do not be skeptical when looking at the price. This is a RTF special, and is guaranteed to work just as good as units 6x the price , tell all your friends this is the real deal!

    Learn More
  4. Regular Price:

    $0.99
    Very Small. Great for 3S to 4S systems Learn More
  5. Regular Price:

    $0.99
    Very Small. Great for 3S to 4S systems Learn More
  6. Regular Price:

    $0.99
    Very Small. Great for 4S systems Learn More
  7. Regular Price:

    $1.25

    Perfect for any of our Mid sizes escs.

    F-12A FIRE RED SERIES

    F-15A FIRE RED SERIES

    Learn More
  8. Regular Price:

    $3.25

    Do not be skeptical when looking at the price. This is a RTF special, and is guaranteed to work just as good as units 6x the price , tell all your friends this is the real deal!

    NOW with a switch. The switch turns off the power completely 

    Base off the  " "L-C Power Filter-1.7A"  this filter will Clean up and dirty power supply. This is a compact and effective LC filter designed to clean a noisy DC power supply. Perfect for sensitive FPV- and RC-components in a single battery setup. The filter has properties to reduce the effects of interference radiated through the air and noise conducted via the power wires. One advantage of this filter is that both the negative and positive leads are filtered (common mode).

    Suitable for setups up to 16V and maximum 3A  load. Problems often occur on sensitive FPV video systems when long power leads (7cm+) are used, limited space for wiring, improperly filtered transmitters, noise from speed controller or switch mode DC-DC voltage converter, or most commonly a shared battery is used to minimize weight. The interference can result in video lines, banding, random drop-outs, and reduced transmission range. A low-pass LC-filter will help attenuation most of the high frequency power supply noise and interference.

    Learn More
  9. Regular Price:

    $0.99

    This is a redesigned mini voltage regulator. 5-23v and with the turnning  the small dial to regulate it's output down to 1v-17v.

    Only a fraction of the size and price of a normal one, this is sure to be the best for only a buck

    check voltage with a voltmeter before installing.

     

    Learn More

Grid List

Set Descending Direction

1-10 of 45

Page:
  1. 1
  2. 2
  3. 3
  4. 4
  5. 5