Build A Quad
Regular Price: $1.99$1.99
Regular Price: $1.99$1.99
Regular Price: $0.75$0.75
Out of stock
XT30 is the new connector on the block and it is perfect for Mini RC use! Forget about mini JST or Mini T-connectors or even bulky XT60 for smaller applications, we have designed the XT30 to meet the needs of the mini revolution. From 250 class Quadcopters to foamy flyers this is the new standard for you!
Made from high-temp Nylon and gold plated spring connectors, both are included in the same injection mold at the time when forming the connector. The XT30 ensures a solid high-amp connection, perfect for applications up to and beyond 35A constant.
XT30, Designed by hexTronik to be more reliable and a better quality connection than Mini Deans T-Connectors and Mini JST for the given size and weight.
There is no patent on the XT30 connector, we hope this product is sold everywhere in the world and dominates the market, reducing customer dependency on the over-priced and underperforming alternatives for this amp class.
• Gold plated Connections
• Long connection contact points for better current flow
• Fills a gap for the Mini connectors
• Small and light weight
Amps: 30A Continuous
Weight: 0.7g male, 0.9g female, 1.7g as a set
Size: Male=12x11x6mm Female=13x11x6mm
Contact current transfer size: 2x6mm
Regular Price: $2.50$2.50
Now in a mini designed for mini Quads!! In our testing this unit will save your camera and VTX in a system with active braking ESC, that can back-feed Spikes into the system. If you have room and we highly recommend the normal units for maximum protection.
Base off the " "L-C Power Filter-1.7A" this filter will Clean up and dirty power supply. This is a compact and effective LC filter designed to clean a noisy DC power supply. Perfect for sensitive FPV- and RC-components in a single battery setup. The filter has properties to reduce the effects of interference radiated through the air and noise conducted via the power wires. One advantage of this filter is that both the negative and positive leads are filtered (common mode).
Suitable for setups up to 16V and maximum 3A load. Problems often occur on sensitive FPV video systems when long power leads (7cm+) are used, limited space for wiring, improperly filtered transmitters, noise from speed controller or switch mode DC-DC voltage converter, or most commonly a shared battery is used to minimize weight. The interference can result in video lines, banding, random drop-outs, and reduced transmission range. A low-pass LC-filter will help attenuation most of the high frequency power supply noise and interference.Do not be skeptical when looking at the price. This is a RTF special, and is guaranteed to work just as good as units 6x the price , tell all your friends this is the real deal!Learn More
Regular Price: $2.00$2.00
Power distribution board with 5V BEC output.Learn More
This quality and handy power distribution board is specially designed for multirotors and is the ultimate solution for tidy power distribution wiring.
There are total 6 positive and 6 negative outputs in two inputs letting you fly Quads, Hex, Octos with a few extra pads for FPV gear. This new mini board will make your installation super clean and easy.
Any group of + and - pads can be used for battery voltage input and output, except for the 5v output.
We recommend this board on 200-450 size multirotors. Using this board on big size multirotors that run a much higher current may damage this board and lead to serious damages.
Input voltage: 2-4S LiPo
Maximum current: 20A
Weight: 8 grams
BEC output: 5V