All FC's are Tested and Shipped w/ NEWEST BetaFlight 3.5.1 (september 8th)! Departing from Florida, U.S.A.  

FC Accessories

Grid List

Set Descending Direction

1-10 of 11

Page:
  1. 1
  2. 2
  1. Regular Price:

    $1.99
  2. Regular Price:

    $0.99
    View Details
  3. Regular Price:

    $2.50

    Now in a mini designed for mini Quads!! In our testing this unit will save your camera and VTX in a system with active braking ESC, that can back-feed Spikes into the system. If you have room and we highly recommend the normal units for maximum protection.

    Base off the  " "L-C Power Filter-1.7A"  this filter will Clean up and dirty power supply. This is a compact and effective LC filter designed to clean a noisy DC power supply. Perfect for sensitive FPV- and RC-components in a single battery setup. The filter has properties to reduce the effects of interference radiated through the air and noise conducted via the power wires. One advantage of this filter is that both the negative and positive leads are filtered (common mode).

    Suitable for setups up to 16V and maximum 3A  load. Problems often occur on sensitive FPV video systems when long power leads (7cm+) are used, limited space for wiring, improperly filtered transmitters, noise from speed controller or switch mode DC-DC voltage converter, or most commonly a shared battery is used to minimize weight. The interference can result in video lines, banding, random drop-outs, and reduced transmission range. A low-pass LC-filter will help attenuation most of the high frequency power supply noise and interference.Do not be skeptical when looking at the price. This is a RTF special, and is guaranteed to work just as good as units 6x the price , tell all your friends this is the real deal!

    Learn More
  4. Regular Price:

    $17.00

    This feature packed board has power distribution for your ESC in a reasonable layout .Packed also with a LC,and 5V 12V bec output,power for OSD,camera,LC filter to avoid the noise.

    Includes a full Minim OSD - you can use the popular MWOSD which in the latest beta includes support for betaflight or any of the other popular variants of the minim osf firmware.This also includes most of the features of the Power pro  including the LC filter, 12 & 5v bec.

    Can be run stand alone without a flight controller connection to provide battery voltage and powered up time - or combine with a gps for a stand alone option in a fixed wing.This has been pre bridged with the most popular voltage out options for camera and vtx but if you do need 5v rather than 12v to your camera or vtx it is easy adjusted.  Also like the PBD if you are running 3s you have the option of feeding the 12v output direct from the battery or through the regulator - most other boards don't give you that option.Easy solder pads for your esc's with the option to feed the esc wires up from underneath for a clean build.35x35mm with 30.5mm mounting holes so it is easily stack-able with your existing mini quad flight controller

    Learn More
  5. Regular Price:

    $3.25

    Do not be skeptical when looking at the price. This is a RTF special, and is guaranteed to work just as good as units 6x the price , tell all your friends this is the real deal!

    NOW with a switch. The switch turns off the power completely 

    Base off the  " "L-C Power Filter-1.7A"  this filter will Clean up and dirty power supply. This is a compact and effective LC filter designed to clean a noisy DC power supply. Perfect for sensitive FPV- and RC-components in a single battery setup. The filter has properties to reduce the effects of interference radiated through the air and noise conducted via the power wires. One advantage of this filter is that both the negative and positive leads are filtered (common mode).

    Suitable for setups up to 16V and maximum 3A  load. Problems often occur on sensitive FPV video systems when long power leads (7cm+) are used, limited space for wiring, improperly filtered transmitters, noise from speed controller or switch mode DC-DC voltage converter, or most commonly a shared battery is used to minimize weight. The interference can result in video lines, banding, random drop-outs, and reduced transmission range. A low-pass LC-filter will help attenuation most of the high frequency power supply noise and interference.

    Learn More
  6. Regular Price:

    $0.99

    This is a redesigned mini voltage regulator. 5-23v and with the turnning  the small dial to regulate it's output down to 1v-17v.

    Only a fraction of the size and price of a normal one, this is sure to be the best for only a buck

    check voltage with a voltmeter before installing. ultra Small DC-DC 3A power Step-Down Adjustable Module Buck Converter 24V To 12v 9V 5V 3V for Arduino

      Learn More
  7. Regular Price:

    $4.50

    This small Converter converts Futaba SBus Signal (inverted serial 100000 baud) to PPM (Pulse Position Modulation) or Spektrum Serial (serial 115200 baud)

     

    https://github.com/sebseb7/SbusToPPM

    Learn More
  8. Regular Price:

    $14.00

    PWM SBus signal converter has been designed to allow the user to convert an input PWM signal into a corresponding SBUS PPM signal output.

    Specs:
    Input voltage: 3.3 ~ 12V
    Supports: Reverse polarity protection
    Accuracy: 4000 count per 1ms  (10PPM source )
    Signal Generator: Hardware anti interrupt program
    Weight:
    Dimensions: 

    Learn More
  9. Regular Price:

    $2.75

    Do not be skeptical when looking at the price. This is a RTF special, and is guaranteed to work just as good as units 6x the price , tell all your friends this is the real deal!

    Base off the  " "L-C Power Filter-1.7A"  this filter will Clean up and dirty power supply. This is a compact and effective LC filter designed to clean a noisy DC power supply. Perfect for sensitive FPV- and RC-components in a single battery setup. The filter has properties to reduce the effects of interference radiated through the air and noise conducted via the power wires. One advantage of this filter is that both the negative and positive leads are filtered (common mode).

    Suitable for setups up to 16V and maximum 3A  load. Problems often occur on sensitive FPV video systems when long power leads (7cm+) are used, limited space for wiring, improperly filtered transmitters, noise from speed controller or switch mode DC-DC voltage converter, or most commonly a shared battery is used to minimize weight. The interference can result in video lines, banding, random drop-outs, and reduced transmission range. A low-pass LC-filter will help attenuation most of the high frequency power supply noise and interference.

    Learn More

Grid List

Set Descending Direction

1-10 of 11

Page:
  1. 1
  2. 2