All FC's are Tested and Shipped w/ NEWEST BetaFlight 3.5.1 (september 8th)! Departing from Florida, U.S.A.  

Flip Series

Grid List

Set Descending Direction

41-50 of 55

  1. $27.00
    View Details

    We have teamed up with some of the best FPV pilots to provide a board just for them.  Supports SBUS and PPM. 3 LDOS for Sensors/MCU/ and extra devices. Build in convert for actuate Voltage and Current reading. Plug and Play with APM power modals, and all our Power distribution boards with sensors built in 

    • STM103 MCU Runs cleanFlight or baseflight
    • 8PWM output
    • Onboard MS5611 Barometer
    • Onboard compass
    • 35x35 size w/ 30.5x30.5 mounting holes
    • onboard USB
    • Optimized 3.3 power supply
    • 3 LDO Sensors/MCU/Extra decives 
    • Plug and Play with APM based power modals
    • Pin header port for motors 1-4 
    • WS2812B LED stick port 
    • 4in1esc port
    • GPS port
    Learn More
  2. $30.00
    View Details

    New .Improved robust components for the UBEC. ALL NEW 2.0 ARE PASSING TEST WITH FLYING COLORS; ORDERS ARE NOW SHIPPING ! Only at RTFQuads.com make sure your getting the newest board. Most important correctly tested to get you in the air faster, and keep you here longer

    The Flip32 v2./ All in One is based off the Flip32 Lineup, but packs all the features in one small board, but it has integrated MiniOSD, PDB, BEC and Current and voltage sensors, soulation for FPV, incl. almost everything FPV needed (excl. RF) on 35x35 mm PCB. RTF Quads has always shipped v2 of the AIO.

    Important : Comes Pre- flashed with CleanFlight 1.11.0 , and the latest OSD release,osd-1.5.1.0, so your are ready to fly. .. get OSD software GUI here. All of the correct changes are done. all pre flashed. nothing for you to do but fly. ( #define CLEANFLIGHT, FC_VOLTAGE_CONFIG ect..) (Please login to see best price for your area)  These come pre-tested on our a very complicated and expensive testing rig to insure your getting a correctly working board every time.

    • STM103 MCU runs Cleanflight firmware
    • Only 35x35mm, mount holes 30x30mm
    • Onboard USB
    • incl. 5V 3A UBEC
    • incl. complete OSD hardware, Compatible with MinimOSD/MWOSD/CC3D OSD
    • incl. one small PDB
    • incl. Current and voltage sensors
    • The default firmware of OSD for Cleanflight
    • The board can support 2-6S.
    • The board can take 80amps current sensor(Burst 110Amps)
    • For switch the usb connection, USB to Flip32 or USB to OSD or Flip32 to OSD
    ••  Comes with EZ Female ESC Cable (not found in any shop)
    ••  Reinforced USB port. ( not found in any other shop)

     

    Learn More
  3. $35.00
    View Details

    New .Improved robust components for the UBEC. ALL NEW 2.0 ARE PASSING TEST WITH FLYING COLORS; ORDERS ARE NOW SHIPPING! Only at RTFQuads make sure your getting the newest board. Most important correctly tested to get you in the air faster, and keep you here longer

    The Flip32 v2./ All in One is based off the Flip32 Lineup, but packs all the features in one small board, but it has integrated MiniOSD, PDB, BEC and Current and voltage sensors, soulation for FPV, incl. almost everything FPV needed (excl. RF) on 35x35 mm PCB. RTF Quads has always shipped v2 of the AIO.

    Important : Comes Pre- flashed with CleanFlight 1.11.0 , and the latest OSD release,osd-1.5.1.0, so your are ready to fly. .. get OSD software GUI here. All of the correct changes are done. all pre flashed. nothing for you to do but fly. ( #define CLEANFLIGHT, FC_VOLTAGE_CONFIG ect..) (Please login to see best price for your area)  These come pre-tested on our a very complicated and expensive testing rig to insure your getting a correctly working board every time.

    • STM103 MCU runs Cleanflight firmware
    • Only 35x35mm, mount holes 30x30mm
    • Onboard USB
    • incl. 5V 3A UBEC
    • incl. complete OSD hardware, Compatible with MinimOSD/MWOSD/CC3D OSD
    • incl. one small PDB
    • incl. Current and voltage sensors
    • The default firmware of OSD for Cleanflight
    • The board can support 2-6S.
    • The board can take 80amps current sensor(Burst 110Amps)
    • For switch the usb connection, USB to Flip32 or USB to OSD or Flip32 to OSD
    ••  Comes with EZ Female ESC Cable (not found in any shop)
    ••  Reinforced USB port. ( not found in any other shop)

     

    Learn More
  4. Regular Price: $21.00

    Special Price $19.00

    View Details

    Now Loaded with CleanFlight, BetaFlight , OR RaceFlight. please choose below.

    NOW SHIPPING 2.0. All boards have 128Mb of flash  Right angle Spectrum pin heads. & Optimized pin placement 

    Flip 32 F3 Racer Flight controller is built with the next generation F3 processor, great for multirotors FPV racing and  allows more configuration options. Super convenient four pin UART headers for full power and ground with both Rx and TX lines. Full three header pins for Rc motors, and even more convenient Pin header type for the RcInput to maximize space. More UARTS available (3 ports!) allows easy use of all the extra items like Blackbox SD, OSD, GPS, SBUS, smart-port. Uart is supported to be software configurable inversion. no hardware inverted is needed for Frsky type SBUS. Faster processor can run higher gryo sync rates without compromising other functionality like the LEDs,Blackbox or accelerometer. The board has dedicated ports for the serial LED strips and spectrum satellite With All Through-hole RC header Type, with no wasted place. Flat bottom for those super tight installs. Comes with 64Mb or 128Mb DataFlash. BlHeli Pass throught is supported. Sporting the gyro with the lowest noise. Pin headers or wires can be installed on the Vbat and Rssi pins. 

    Supports ALL flight control firmware compatible with SPRacingF3 targets!

    Features:
    3 UART’s  Total - 8 PWM outputs for Motors & Servos.
    RSSI port - S.BUS, SumH, SumD, X.BUS & Spektrum Satellite supported.
    STM32 F3 processor with hardware floating point unit.
    Dedicated LED output for up to 32 programmable LEDs. 
    36x36mm form factor with M3 mounting holes (30.5mm hole spacing).
    STM32 F3 processor with hardware floating point unit.
    Tx/Rx on S-Bus port (UART3)
    Normal header pins
    Built-in inverter for SBUS
    Voltage (VBAT) and Buzzer ports
    SPRacingF3 firmware hex file
    Spectrum Sat. port installed
    RGB LED Port! - Buzzer port for audible warnings.
    Flash memory for Blackbox! (64Mb or 128Mb)
    Built-in inverter for SBUS
    easy bootloader pins
    compact size

    Find the RaceFlight GUI HERE  RFC_1.3.4444.4 . Load into chrome by going to into your Extension Tab, under settings, in the "hamburger" menu. and dragging and dropping the .crx file info that window. a box will pop up saying "drop to install"

    Learn More
  5. Regular Price: $28.00

    Special Price $25.00

    F3 MCU, incl. F3 FC ACRO and MinimOSD. UART, Blackbox

    STM32 F303 MCU,

    Runs Cleanflight firmware • SPRacing HEX

    8PWM input (Pinheaders) •

    8PWM output (Pinheaders) •

    Mounting holes 30.5x30.5mm •

    128Mb Flash(16M Byte)

    Learn More
  6. $35.00
    View Details

    Flip 32 F3 OSD Flight controller is built with the next generation F3 processor, great for multirotors FPV racing and  allows more configuration options. Build in OSD! 

    Default shipping firmware:   Short OSD UP and 3.3V to upload OSD chip . 

    OSD: scarab-osd-1.5.2.4

    FC:CleanFlight 1.12.0

    Features:
    Build in OSD
    RSSI port
    F3 processor

    Normal header pins
    Built-in inverter for SBUS
    Voltage (VBAT) and Buzzer ports

    Spectrum Sat. port installed
    RGB LED Port!
    Flash memory for Blackbox! ( 128Mb)
    Built-in inverter for SBUS
    easy bootloader pins
    compact size 

    Learn More
  7. $24.00
    View Details

    This is a micro version of Flip32, designed for use with Cleanflight or baseflight. With USB port. ACro does not come with a BARO.

    NOTE: This is a PPM sum/S-bus/Spectrum satellite controller only .make sure to add an ppm encoder if you want to use a normal pwm rx 

    Learn More
  8. $15.00
    View Details

    This is a micro version of Flip32, designed for use with Cleanflight or baseflight. With USB port. ACro does not come with a BARO.

    NOTE: This is a PPM sum/S-bus/Spectrum satellite controller only .make sure to add an ppm encoder if you want to use a normal pwm rx 

    Learn More
  9. $22.00
    View Details

    This is a micro version of Flip32, designed for use with Cleanflight or baseflight.

    NOTE: This is a PPM sum/S-bus/Spectrum satellite controller only .make sure to add an ppm encoder if you want to use a normal pwm rx 

    Learn More
  10. Regular Price: $20.00

    Special Price $15.00

    View Details

    When size and weight matters the most. the Racing Edition is a 30x17mm board size is about half the size. This is a micro version of the Flip32.

    30mm x 17mm
    2 gram without headers
    STM32F103CBT6 32-bit Cortex M3 processor
    MPU6050 Accelerometer/Gyro
    Full PWM/PPM RC Input
    6 motor outputs for multi-rotors
    Batt/voltage monitoring
    Onboard USB plug 
    Three Status LEDS
     
    comes Cables for radio , and for buzzer and BATT ports 
    Learn More

Grid List

Set Descending Direction

41-50 of 55