All FC's are Tested and Shipped w/ NEWEST BetaFlight 3.4.0(July 8th)! Departing from Florida, U.S.A.  

Flip 32 - F3 V2 (128Mb Flash)

Flip 32 - F3 V2 (128Mb Flash)

Regular Price: $21.00

Special Price $19.00

Now Loaded with CleanFlight, BetaFlight , OR RaceFlight. please choose below.

NOW SHIPPING 2.0. All boards have 128Mb of flash  Right angle Spectrum pin heads. & Optimized pin placement 


Flip 32 F3 Racer Flight controller is built with the next generation F3 processor, great for multirotors FPV racing and  allows more configuration options. Super convenient four pin UART headers for full power and ground with both Rx and TX lines. Full three header pins for Rc motors, and even more convenient Pin header type for the RcInput to maximize space. More UARTS available (3 ports!) allows easy use of all the extra items like Blackbox SD, OSD, GPS, SBUS, smart-port. Uart is supported to be software configurable inversion. no hardware inverted is needed for Frsky type SBUS. Faster processor can run higher gryo sync rates without compromising other functionality like the LEDs,Blackbox or accelerometer. The board has dedicated ports for the serial LED strips and spectrum satellite With All Through-hole RC header Type, with no wasted place. Flat bottom for those super tight installs. Comes with 64Mb or 128Mb DataFlash. BlHeli Pass throught is supported. Sporting the gyro with the lowest noise. Pin headers or wires can be installed on the Vbat and Rssi pins. 


Supports ALL flight control firmware compatible with SPRacingF3 targets!


Features:
3 UART’s  Total - 8 PWM outputs for Motors & Servos.
RSSI port - S.BUS, SumH, SumD, X.BUS & Spektrum Satellite supported.
STM32 F3 processor with hardware floating point unit.
Dedicated LED output for up to 32 programmable LEDs. 
36x36mm form factor with M3 mounting holes (30.5mm hole spacing).
STM32 F3 processor with hardware floating point unit.
Tx/Rx on S-Bus port (UART3)
Normal header pins
Built-in inverter for SBUS
Voltage (VBAT) and Buzzer ports
SPRacingF3 firmware hex file
Spectrum Sat. port installed
RGB LED Port! - Buzzer port for audible warnings.
Flash memory for Blackbox! (64Mb or 128Mb)
Built-in inverter for SBUS
easy bootloader pins
compact size


Find the RaceFlight GUI HERE  RFC_1.3.4444.4 . Load into chrome by going to into your Extension Tab, under settings, in the "hamburger" menu. and dragging and dropping the .crx file info that window. a box will pop up saying "drop to install"

Regular Price: $21.00

Special Price $19.00

 
Description

Details

Flip 32 F3 Racer Flight controller is built with the next generation F3 processor, great for multirotors FPV racing and  allows more configuration options.

Introductory price

Features:
3 UART’s  Total 
RSSI port
F3 processor
Tx/Rx on S-Bus port (UART3)
Normal header pins
Built-in inverter for SBUS
Votlage (VBAT) and Buzzer ports
SPRacingF3 firmware hex file
Spectrum Sat. port installed
RGB LED Port!
Flash memory for Blackbox! 
Built-in inverter for SBUS
easy bootloader pins
compact size 

Flip 32 F3 Racer Flight controller is built with the next generation F3 processor, great for multirotors FPV racing and  allows more configuration options. Super convenient four pin UART headers for full power and ground with both Rx and TX lines. Full three header pins for Rc motors, and even more convenient Pin header type for the RcInput to maximize space. More UARTS available (3 ports!) allows easy use of all the extra items like Blackbox SD, OSD, GPS, SBUS, smart-port. Uart is supported to be software configurable inversion. no hardware inverted is needed for Frsky type SBUS. Faster processor can run higher gryo sync rates without compromising other functionality like the LEDs,Blackbox or accelerometer. The board has dedicated ports for the serial LED strips and spectrum satellite With All Through-hole RC header Type, with no wasted place. Flat bottom for those super tight installs. Comes with 64Mb or 128Mb DataFlash. BlHeli Pass throught is supported. Sporting the gyro with the lowest noise. Pin headers or wires can be installed on the Vbat and Rssi pins. 

Supports ALL flight control firmware compatible with SPRacingF3 targets!

Features:
3 UART’s  Total - 8 PWM outputs for Motors & Servos.
RSSI port - S.BUS, SumH, SumD, X.BUS & Spektrum Satellite supported.
STM32 F3 processor with hardware floating point unit.
Dedicated LED output for up to 32 programmable LEDs. 
36x36mm form factor with M3 mounting holes (30.5mm hole spacing).
STM32 F3 processor with hardware floating point unit.
Tx/Rx on S-Bus port (UART3)
Normal header pins
Built-in inverter for SBUS
Voltage (VBAT) and Buzzer ports
SPRacingF3 firmware hex file
Spectrum Sat. port installed
RGB LED Port! - Buzzer port for audible warnings.
Flash memory for Blackbox! (64Mb or 128Mb)
Built-in inverter for SBUS
easy bootloader pins
compact size

Reviews