These are Pre-configured, Flashed with the correct settings, and tested to make them as Plug and Play as possible. This is NOT normally done in any other store!
All new sensors!
• Atmega2560 - Super fast, tons of memory.
• ITG3205 Triple Axis Gyro. MPU6050 Six Axis Gyro/Accelerometer
• BMA180 Accelerometer.
• BMP085 Barometer. MS5611 Barometer
• HMC5883L Magnetometer
• Servo output for camera pitch and roll control
• Supports direct connection of GPS module
• On-board USB connection for programming
Pre-loaded with customized firmware, and programed to fly almost out of the box with most any ESC's
To reflash the board, using the IMU config as : //FFIMUv43
If you would like pin headers install, Please select the option below
Now you are able to take advantage of 4 AUX Channels on a traditional receiver ! with 2 or 3 position switches you have ultimate flexibility!!!
4 serial ports. Keep your Bluetooth/3dr connected and still use the USB port.
Get all the firmware, stick commands, drivers, documents, arduino.
Everything you need to fly in one place!