The Evolution of MEGA
MultiWii Pro V3 Flight controller -Same great sensors as The Mega 2.0, but now with the Ez-connect system.
This combo is flashed, tested and checked for i2c errors so you are ready to fly. Offering unlimited control to the piloting giving the "locked in" feel not found anywhere else - and leading edge features: self leveling,Trick/Flip recovery, GPS hold and GPS return, OSD, waypoint support.
Includes ALL the missing Atmega2560 I/O pins that are needed for taking full advantage of the MultiWii and MPNG feature set.
• Atmega2560 - Super fast, 4 times the memory over 328p
• MPU6050 Six Axis Gyro/Accelerometer
•. MS5611 Barometer
• HMC5883L Magnetometer (remote locateble)
• Servo output for camera pitch and roll control
• Spektrum Satellite receiver direct connection!
• Direct Futaba s-sub connection
• Larger and faster Serial GPS computation - uBlox Neo 6M/6H with compass for better PHold/RHome/WayPoints
• Supports direct connection of GPS module
• Essentials for higher power current systems.
• Remote Compass - designed to be remote located away from EMI
• 2 EZ - I2C connections for EZ connection of oLED and LED Ring, ect.. with 5v and 3.3v regulator
• Tested and proven by the MultiWii community, and flown by some of the best rc pilots from around the world.
• Thick copper for strong solder joints,vibration and crash survival
• EZ connection port for KV Modded OSD x 4 inputs - OSD Voltage 1&2 - current senser - Rssi
• A0->A7 pinned out to allow further expert coders - battery monitor via A0, sonsor, ect..
• 4 Serials with EZconnectors (Serial 0=USB/Bluetooth/3drRadio/osd)(Serial 1=PPMSUM) (Serial 2=GPS Serial) (serial 3 = open)
• 8 Engine outputs - Tricopter, Quads, Hexi, YSix, Yfour,Vtail,Aippane, Octas, and more; and 2 servos at the same time and 3 Servo gimbal drivers
• No soldering -- tested and pre-programmed ! finished
• Mega Pirates NG software compatible, Open source MultiWii software 2.3 intsalled
• On board USB connects to PC Win7/8 or Mac OSX using the .NET or JAVA
Mounting: Standard Mk style mounting holes 45mm X 45mm
Pre-loaded with QUADX (unless other motor plan selected, see below) and programmed to fly almost out of the box with most any ESC's.
One 10-pin Radio Rx cable and one 6-pin Quad/Tri motor outputs cable is included.
Get all the firmware, stick commands, drivers, documents, arduino.
Here is everything you need to fly in one place!
All the cables Plug and Play for GPS, 3dRradios, and LED ring to the MEGA board is configured to order.
Purple = throttle
Gray = Aileron
Brown = elevator
Orange = rudder
White = gear channel
Green = aux one channel
Blue = aux two channel
Yellow = aux three channel
Red=VIN = 5+ power to RX
Black=GND = ground to RX
Yellow= front left
Green = back right
White= back left
Mega v3.21 Black