Regular Price: $17.99
Special Price $9.99
Its time for an upgrade! BL Heli_S capable ESCs are here!
These Emax Lightning 35A BL Heli_S ESCs have been fully tested and are compatible with Bl Heli Suite for the best performance for a quad!
Before Purchasing:FLIGHT CONTROL FIRMWARE COMPATIBLITY LIST:
CLEANFLIGHT: 1.9 - 1.13
BETAFLIGHT: 2.7.1, 2.8.1 (2.9 not compatible)
Other firmwares may be operational but may not be fully supported so be careful and use at your own risk.
1. BLHeli_S ESC with Hardware generated PWM synchronous to MCU yields ultra-quiet motor performance.Learn More
2. Utilizes high-performance EFM8BB2 50MHz MCU
3. Lightweight: 4.2g = without heatsink & without wires / 5.6g = with heatsink & without wires / 14g = with heatsink and with all wires.
4. Footprint: 32.6*18.0*6.5 (mm)
5. Only supports Damped Light (Active Braking is the only option for BLHeli_S)
6. FW upgradable via signal wire (BLHeli_S HEX needed)
7. Anti-counterfeit code of authenticity.
8. Dynamic voltage range - Supports 2S up to 4S Input Voltage.
9. Supports Motors with super high KV (EFM8BusyBee 50MHz can handle up to 500k eRPM).
10. Supports 1-2ms signal, Oneshot125, Oneshot42, and Multishot.
11. High-current burst rating.
12. High-Resolution Throttle steps (512 to 2048 steps depending on hardware configuration).
13. Hardware PWM refresh rate up to 36khz with BLHeli_S (Regular BLHeli with Software PWM runs at 16khz). (Faster rate allows more input signal in same given amount of time resulting in smoother and more responsive throttle.)
14. BEC: No Built-In BEC
Regular Price:$8.50$8.50View Details
Out of stockNEW. these are the units that do not overheat. THEY DO COME WITH RP-SMA. WE CAN REMOVE THE SMA PLUG FROM THE PCB TO BARE PADS TX SO YOU CAN SOLDER ON YOUR OWN IF NEEDED...Learn MoreDescription:Brand Name: EachineItem Name: VTXItem NO.: TS5840Transmit frequency: 5.6-5.9GhzInput voltage: 7-24VTransmit power: 200mWWorking current: 190mA/12VWorking temperature: -10~85 CelsiusVideo bandwidth: 8MAudio code: 6.5mPlug: RP-SMA, SMADimension: 30*20*8mmWeight: 7.3g
classifieds Item # 12 - OMNIBUS Betaflight 3.1 F3 6DOF Mini Flight Controller 20x20mm Integrated OSD Built-in 5V BEC
These were only used for R&D purposes and only probed with an oscilloscope never installed , the 5-volt and 3 volt line are super dirty and I would not trust the built-in bec at all. Overheats and starts to output a ton if noise all the samples. but seems to all work....
Description:Item name: Betaflight 3.1 F3 6DOF Mini Flight ControllerSize: 27x27mmMounting holes: 20x20mmWeight: 3.1g
Betaflight target: betaflight_3.1.0_OMNIBUSFeatures:Runs betaflight_3.1, the latest firmware that supports Dshot ESC driveUses the MPU6000 over SPI for the best possible flight performance.CPU: STM32F303CCT6 (72MHZ, 256K FLASH)Sensor: SPI Sensor MPU-6000 triaxial accelerometer / triaxial gyroscopePower supply: 2-3S (7.4V-12.6)BEC: built-in 5V/500MAWith buzzer portWith PDB distributor for ESCsSupports BLheli suite ESC programmeBuilt-in voltage detection and alarm functionReceiver:Supports Sbus or serial port RX port, Spektrum 1024/2048, SBUS, XBUS, SumD and SumH RX, built-in inverter.Supports 3.3v Spektrum satellite receiverSupports PPM receiverReceiver configuration:SBUS or DSM receiver input, please configurate RX3 as input interface.DSM receiver powered from 3.3VSBUS and PPM from 5VPackage included:1 x Betaflight 3.1 F3 6DOF Mini Flight ControllerLearn More