NOW WITH 3.1V REG!
This is revision 0.2b WITH changed vreg to 3.1V. These boards have the new 3.1V Regulator installed on the board. Do not get stuck with an older 3.0v reg. [revision 0.2b] . Recently there was a design change to use a 3.1V voltage regulator. The ones with the 3.0V regulator have some issues to start the ESCs as long as the batteries are fully charged. We have the 3.1V regulator so you will not have any problem. Super light for indoor brushless fpv racing.
Support Current, Voltage Monitoring. Changed vreg to 3.1V.
ALL CREDITS GO TO FISHPEPPER. HIS BLOG . thank you for all the hard work. please support
tinyFISH F3 Flight Controller brings incredible power and performance to the micro brushless world. It uses a powerful F3 processor along with top of the line hardware. Now you can get all the performance from an F3 based flight controller in a truly micro size! This flight controller uses 16x16mm mounting holes and a low profile design allowing for smaller airframe designs than ever before. The tinyFISH comes with BetaFlight pre-installed.
The tinyFISH F3 Flight Controller has a built 8CH SBUS FrSky compatible receiver, making setup a breeze. This flight controller has been designed by and named after our friends at fishpepper.de under an open source license.
tinyFISH F3 version 0.2b 16x16mm Flight Controller w/ Built-in 8CH SBUS FrSky Receiver
Designed by a German engineer and published as a TinyFish open source project this incredibly tiny flight controller with integrated FrSky receiver is a real revolution in FPV racing drone world.
With just 1.7g weight and support of up 3s batteries TinyFish flight controller will make your FPV racing drone lighter, faster and let you fly longer. Build the smallest and lightest racing drone in the world and fly it like a champ!
- Lipo: 1-3S (1S recommended)
- 16x16mm hole to hole spacing (20x20mm outer dimension
- integrated FrSky compatible SBUS receiver (basically an integrated uSKY rx)
- STM32F3 CPU
- MPU-6000 SPI gyro
- 3.1V regulator
- supports DSHOT
- integrated Blackbox dataflash
- integrated voltage- and current-sensor
- buzzer output
- rgb led output
- open hardware
- weight: 1.7g
tinyFISH F3 (ver. 0.2b w/ 3.1v Reg) 16x16mm Flight Controller w/ Built-in 8CH SBUS FrSky Receiver