Please expect some delay in testing for July 2021.All flight controllers flashed and tested with newest firmwre before shipping, Departing from Florida, U.S.A.  

20A NakedBee ESC

20A NakedBee ESC

Oh shit, get some heatshrink on these!

Have you ever took all the heat shrink and wires off just to put them back on again ? Ready to install with no wires. Ready for the tight installs. Supporting 2-4S - these ESCs have been the closest performing ESCs to KISS, mosfet driven with fast, dedicated driver chips on quality PCB. This gives you excellent freewheeling and exceptional braking. The next generation in speed controllers! With Silabs processor and gate-drivers which makes the motor braking especially fast. These are OPTO ESCs - this means that you will need your own 5 volt BEC to power your flight controller.  Do not forget a RTF 1V-17V ADJUSTABLE VOLTAGE REGULATOR

Comes with bootloader enabled. Do not forget a ESC programmer.

Full warranty  for any defective product. Please contact us if you have any problem upon arrival! Fly with confidence!




The Latest BLHeli Firmware
Silabs MCU
DLM and Oneshot Capable
Signal wire programmable

Input: 2-4s Lipo
Constant: 20 Amps
Burst: 30 Amps
Weight: 4g w/wires
Dimensions: 23x12.5x3mm
Motor wire: 50mm 20g
Signal wire: 100mm 22g
MCU: Silabs
PCB - 4 Layer Blind Pole PCB - 3oz Pour
Mosfet: N-Channel
BEC: None

NakedBee is using Silabs processor and fast dedicated driver chips, providing excellent freewheeling and exceptional braking capabilities.

We're only using the best components available, period. And, as we build these in our own factory, our experienced staff ensures you're getting the best of the best!

We know that with mini quads, every gram counts. NakedBee is only 24.5x12.5mm, and weights only 4g, enabling your builds to be even smaller and lighter!

To unleash it's full potential, NakedBee has been designed to run BLHELI firmware. Factory flashed with BLHELI 14, it's ready for action!

Oneshot125 is a different and faster communication protocol between the flight controller and the ESC on your quadcopter. It allows the FC to send control commands to the motor quicker, therefore in theory your multirotor should perform better.

This feature allows your motors to respond to throttle decreases much quicker, allowing for more stable flying, and higher response to throttle decreases.

With the BLHELI software rapidly evolving, you can flash the newest firmware using the 3pin connector and suitable USB adapter*

Once connected, you will get access to a number of settings that control behavior of your ESC controller.

Enable OneShot125, Damped light mode, reverse motor direction, all available on one easy to use screen.

Capable of running 3s and 4s setups, NakedBee can work with up to 20A continuous load, and 30A peak (10s).

Initial stress testing on 4S with a Cobra 2208/2000 with 6x4.5 prop, doing repetitive immediate accelerations from low rpm to full throttle went well. 
During the initial acceleration, this setup pulls about 100A, so it's a tough test for a small ESC (and can break other small ESCs). 
Hopefully this indicates that the ESC will prove to be a reliable performer.

And so far, this is the closest performer to KISS that I have seen in this size.

Here is the link for Blheli suite: