Flight Controller Tested and Flashed shiped BetaFlight 4.0.5 (8/7/2019)! Departing from Florida, U.S.A.  

High Power 500mw 3DR Radio Telemetry Kit 433

High Power 500mw 3DR Radio Telemetry Kit 433
$45.00

SPECIAL : THIS KIT WILL COME WITH A EXTRA ANTENNA FOR THE AIR SIDE. ONE FOR WHEN WEIGHT IS NOT AN ISSUE, FOR MAXIMUM RANGE. IT WILL ALSO COME WITH A SUPER LIGHT ANTENNA LIKE ON THE 100MW UNITS- THIS WILL REDUCE YOUR WEIGHT BUT ALSO YOUR RANGE SLIGHTLY. 


This new High power Telemetry radio set allows you to link to a flight controller such as our RTFlyer or Multiwii to a  computer, laptop or tablet supporting a USB connection (OTG).


 The Radio set not only lets you see live data such as live GPS position overlaid on a map but system voltage, heading, waypoint navigation even artificial horizon and so much more.

* Required Fields

$45.00
 
Description

Details

This new Telemetry radio set allows you to link to a flight controller such as our ReadyToFlyer/apm or Multiwii to a USB or Uart equipped device such as a computer, laptop or tablet supporting a USB connection (OTG). The Radio set not only lets you see live data such as live GPS position overlaid on a map but system voltage, heading, waypoint navigation even artificial horizon and so much more. Using open source MAVlink based ground station software, you can even fly your aircraft with a joystick via your computer and update settings live! Or just use it for your DIY projects that needs a wireless Serial interface. This kit offers a great low price, longer range and superior performance. The system utilizes the 433Mhz band and provides a full-duplex link using HopeRF's HM-TRP modules running custom, open source, firmware.
 
- This is the high power version over 5x power then the normal one. High Power 500mw -'
-All set for Multiwii or APM/Ardupilot- PLUG AND PLAY. Pre-configered and tested and all other settings needed. 
- I preprogram these radios to the correct baud rate so you can just connect them to your flight controller and start chaning PID's on the fly.
- The 3DR Radio telemetry system is designed as an open source Xbee replacement radio set, offering a lower price, longer range and superior performance to Xbee radios. It's available in 433/868Mhz; and in the following configurations:  serial board (for the air) and USB (for the ground). 
- The radio is a 2-way half-duplex wireless communication system with a standard TTL UART interface, based on HopeRF's HM-TRP data link modules, and custom firmware that improves upon the modules' original features and performance.
 - The SiK firmware includes a bootloader that permits radio firmware upgrades over the serial interface, and radio firmware with configurable parameters. Firmware upgrades and configuration are fully supported in the APM Mission Planner. Configuration is also possible through AT commands.

 

3DR Telemetry Kit Specifications

SPECIAL : THIS KIT WILL COME WITH A EXTRA ANTENNA FOR THE AIR SIDE. ONE FOR WHEN WEIGHT IS NOT AN ISSUE, FOR MAXIMUM RANGE. IT WILL ALSO COME WITH A SUPER LIGHT ANTENNA LIKE ON THE 100MW UNITS- THIS WILL REDUCE YOUR WEIGHT BUT ALSO YOUR RANGE SLIGHTLY. 

- Very small size 
- Light weight (under 4 grams without antenna) 
- 433MHz
- Receiver sensitivity to -121 dBm 
- Transmit power up to 500mW 
- Transparent serial link 
- Air data rates up to 250kbps 
- MAVLink protocol framing and status reporting 
- Frequency hopping spread spectrum (FHSS) 
- Adaptive time division multiplexing (TDM) 
- Support for LBT and AFA 
- Configurable duty cycle 
- Built in error correcting code (can correct up to 25% data bit errors) 
- Demonstrated range of several kilometers with a small omni antenna 
- Can be used with a bi-directional amplifier for even more range 
- Open source firmware 
- AT commands for radio configuration 
- RT commands for remote radio configuration 
- Adaptive flow control when used with APM 
- Based on HM-TRP radio modules, with Si1000 8051 micro-controller and Si4432 radio module

Reviews