All FC's are Tested and Shipped w/ NEWEST BetaFlight 3.5.3 (NOV 18th)! Departing from Florida, U.S.A.  

F-30A-HV Fire Red series High voltage (2-6 Cells) OPTO BLHeli-(OneShot)

F-30A-HV Fire Red series High voltage (2-6 Cells) OPTO BLHeli-(OneShot)
$12.00

Flashed with newest BlHeli 14.0.0.2 firmware installed and tested!


This all new ESC was designed ground up for multirotors and uses all new Fets for superior performance. The real benefit to this standout ESC is the high voltage design. With up to 6 cell lipos, you can  have longer flight times without the high weight penalty of all other 6S ESC's on the market. Dampened Light Supported ,OneShot Auto-detect wih a Flip32 based Flight controller


 


Enable Racing Mode! (Dampened Light ) Enable racing mode to change over 10 Settings for maximum performance: : PWM Frequency/Damped, Motor Timing, Beacon strength/Delay,PPM MIN/MAX Throttle are set to maximum performance! Pair with a Flip32 for automatic detection of all the advantages of Oneshot123


 


 


 


It supports damped light mode,oneshot123, overtemp protection and bootloader enabled on input plug


 


 

$12.00
 
Description

Details

This all new ESC was designed ground up for multirotors and uses all new Fets for superior performance. The real benefit to this standout ESC is the high voltage design. With up to 6 cell lipos, you can  have longer flight times without the high weight penalty of all other 6S ESC's on the market.

Features
All new Fets on a compact PCB
Smaller and lighter than standard 30A ESC's
30Amp constant with 35Amp burst
Dual Capacitors for reduced voltage spikes
OPTO, NO BEC ONBOARD

2S through 6S Capable!
 
Weight:
Standard with wires: 25 Grams

Simply put the best ESC you can get for your multirotor. 

  • All N-channel FETs
  • External Oscillator:
  • Boot-loaded Enabled 

Flashed with the famous SimonK OpenSource Firmware for super-fast throttle response, which makes your quad more responsive and "locked in".  These  ESCs do not overheat, burn or lock out - unline many other ESCs flashed with the SimonK firmware. The Gold standard ESC for multirotors. Free reflashing if new firmware comes out, flashed with the  most currect firmware.  ESCs now have the bootload firmware which can be upgraded by using TURNIGY USB Linker.

These ESCs are completely re-designed from the ground up. Flashed with the famous SimonK OpenSource Firmware for better throttle response . New firmware means direct, linear throttle response, making it suitable for multicopter use. Up to 600Hz input rate is supported, with immediate updates to motor pwm duty. Each ESC is tested with a motor before and after loading new firmware.

The the external 16MHz oscillator line up exactly with the numbers in microseconds, but the internal rc oscillator ones will drift quite a bit based on temperature.

The ESCs use only N-channel FETs have the advantage of lower resistance, less losses and hence more efficiency. 

All N-Fet:"The ESCs which use only N-channel FETs have the advantage of lower resistance, less losses and hence more efficiency."*

External Oscillator:"An external oscillator may supply a more consistent timing signal and steadier motor speeds" "but the internal rc oscillator ones will drift quite a bit based on temperature.

These ESCs are a revision of the nearly-perfect F20A & F-30A ESCs with high quality board layout and components to make them perfect. Do not settle for anything less.

NOTE: This firmware does NOT check battery voltage or ESC temperature. Always use a LiPo alarm and monitor pack voltage while using.

NOTE: These are not I2C ESCs and as such are not directly compatible with Mikrokopter-style interface, however they can be used with I2CPWM converter

Reviews