All FC's are Tested and Shipped w/ NEWEST BetaFlight 3.5.3 (NOV 18th)! Departing from Florida, U.S.A.  

Power Module - Current/voltage ONLY

Power Module - Current/voltage ONLY
$6.00
test
OR
 
Description

Details

This is just the current sensor with NO BEC, NO WIRES!


find the full Power module with all wire here

The Power Module incorporates both a way to power your FC and accessories and report battery voltage and current to the FC, this can be viewed in the FC’s stored logs or live with a telemetry radio. All thru a single and tightly included 6-pin cable that directly matches the FC’s connector. The on-board switching regulator outputs 5.3V at a maximum of 2.25A, and can be used up to 18 Volts (4S LiPo) and at a maximum of 90 amps. T

Note: The Power Module is rated at 2.25 Amps to power the FC, receiver and peripherals (GPS and Telemetry radio) ONLY. To power servos use an ESC with an adequate BEC or a standalone BEC plugged into the output bus, and remove jumper 1 to isolate the two power lines.

Specifications:
Max input voltage: 18V
Max current sensing:90A
Switching regulator outputs: 5.3V at 2.25A max
6-pos Molex cable plugs directly to FC
Voltage and current measurement configured for 5V ADC

Includes:
DF13 6 Position Connector 

Power Module 

Reviews