Please expect some delay in testing for July 2021.All flight controllers flashed and tested with newest firmwre before shipping, Departing from Florida, U.S.A.  

RTF V5 Brushless Gimbal Controller (MOSFET edition)

RTF V5 Brushless Gimbal Controller (MOSFET edition)


This controller is for use with brushless direct drive (BLDC) motors. Included sensor unit with gyro and accelerometer is mounted on the camera platform; the controller unit receives data from IMU to define camera inclination angles. PID-controller calculates the amount of compensation and sends command to the power unit, which controls the current in the windings and thus the direction of the vector of magnetic field in the stator. Magnetic field moves the rotor to the right position.

 The Controller is upgraded with new V5 board that Adopts MOSFET replacing L6234D, provides higher driving power. (5 amps) and new redesigned tiny IMU

Technical Data :

  • USB connector (no FTDI needed)
  • Stabilized VBUS (USB port)
  • Pin layout optimized GND, A1 and A2 GND, multi-port, 5V
  • L6234 brushless motor driver   MOSFET replacing L6234D,
  • 2 outputs for brushless motors
  • 4 receiver inputs
  • 6 analog inputs
  • Serial port available
  • Power LED (blue)
  • Small LEDs on the USB
  • Dimensions 50 mm x 50 mm
  • Standard MK style mounting holes 45 mm x 45 mm
  • 2 instead of 4 glass diodes SOT23
  • 5V better stabilized
  • Shifter lever on the I2C Bus (3.3V to 5V)
  • Pull reduced (for better edges)