All FC's are Tested and Shipped w/ NEWEST BetaFlight 3.5.3 (NOV 18th)! Departing from Florida, U.S.A.  

4 IN 1 ESCs

Grid List

Set Descending Direction

11-16 of 16

Page:
  1. 1
  2. 2
  1. $13.99 As low as: $13.00
    View Details

    Aikon SEFM 20A ESC is the new generation of multirotor speed controller with the latest BLHeli_S software.

    now shipping v2.0 with Added fets 

    Aikon has been working closely with BLHeli group in developing the product for FPV racing community. The first offering of a new generation of BLHeli ESCs.  Designed to bring high performance through hardware PWM and the Silabs Busybee line of microprocessors.  Aikon SEFM 30A speedcontrollers. Busybee processor with hardware PWM timer. Has smoother RPM transition compared to a 'regular' BLHeli esc.These are OPTO ESC. This means that you will need your own 5 volt bec to power your flight controller. Thr benefits are more throttle resolution, smoother response, higher RPM ability and automatic detection of OneShot 125, OneShot 42 and Multishot protocols.

    Enable Racing Mode! (Dampened Light Mode) - Enable racing mode! Settings are changed/tuned for better handing during Racing!: BlHeli 14.6 Firmware! For True Plug and Play settings, more flying and less time on the bench. Racing mode is pre-programmed and optimized for best performance by quadcopter racers - ready for just about any motors - OneShot is included/Ready - for new and starting Flights we recommend not to alter our BL-Heli settings for racing quads. Race mode changes over 10 Settings for maximum performance: PWM Frequency/Damped, Motor Timing, Beacon strength/Delay,PPM MIN/MAX Throttle are set to maximum performance! Pair with a Flip32 for automatic detection of all the advantages of Oneshot123. Newest BL-Heli 14.6 Firmware ships out pre-programmed and tested.

    The SEFM 30A Blheli_S ESC is designed to give silky smooth feeling to the powerful arsenal of Blheli ESCs. Utilizing hardware PWM with the one of a kind EFM BusyBee 48MHz MCU power, SEFM30A coupled with Blheli_S firmware specifically written by Steffen for this ESC has truly bring the open source firmware to a whole new level.

    The first offering of a new generation of BLHeli ESCs. Designed to bring high performance through hardware PWM and the Silabs Busybee line of microprocessors. Stated benefits are more throttle resolution, smoother response, higher RPM ability and automatic detection of OneShot 125, OneShot 42 and Multishot protocols.

    Features

    Totally new MCU that comes with a three channel PMW output specifically designed for motor control applications and runs at 48mhz.
    New BLHELI_S firmware which provides all the strengths of the original BLHELI, but adds some significant improvements such as better response and smoother start up, 1000 steps of throttle input resolution, and auto-detection of the input signal protocol.
    Higher quality MOSFETs with extremely low internal resistance
    Three exceptionally fast dedicated MOSFET drivers
    Extra capacitance to help remove EMF spikes and keep the rest of your equipment safe.
    Specification

    Battery: 2-4s
    Constant Current: 20A
    Burst Current: 30A
    Size: 14 x 25mm
    Firmware: Blheli_S
    MCU: 8BB21
    Bootloader: Yes
    Weight (with wire) 9g
    Signal Wire Length: 150mm
    Battery Wire Length: 100mm

    Specifications:
    Continuous Current: 30A
    Burst Current: 40A
    Input Voltage: 2S-4S LiPO
    Weight: 5.5g with wires and heat shrink wrap
    Dimensions: 25x13mm

    Learn More
  2. Regular Price: $48.00

    Special Price $45.00

    The combination of Blizzards+Bazooksa+Littlebees Pro = A Cavalry packs in a 35x35MM size ready to blast all the power to the motors!  Easy Solder tabs. Strongest braking power. Littlebee smoothness and feel.

    Loaded with the newest 14.4 Firmware . With a New IC driver, this esc is one of the fastest and strongest. The new generation of high-quality IC and 396 Silabs chip imports to make smaller, lighter. With a triple IC drive everything including braking is more sensitive and rapid. Great support for 4S Batteries , making it perfect for racing. active-wheeling technology for a more efficient and quicker throttle response. Twisted pair copper wires to reduce interference signals generated within the transmission,MORE Thrust! HIGHER Top-end Endurance! BETTER Motor Efficiency! FASTER Responsive Time

     

    Bootloader: BlHeli
    Processor: SiLabs F396
    UBEC: N/A
    Lipo Supported : 2 to 4 cells
    Processor: SiLabs F396
    Bootloader: BlHeli (FC pass-throught)
    Firmware: LittleBee 20A Pro
    Servo Cable Flashable - One-Wire-Interface
    BlHeli: Dampend light enabled and OneShot42 compatible
    BlHeli:OneShot125 AutoDecect
    BEC: None
    Naked
    35mm x 35mm x 5mm
    Newest, Strongest, IC driver
    Tons of Power!
    New Dedicated fast switching gate driver

     

    Learn More
  3. $31.00

    The combination of Blizzards+Bazooksa+Littlebees = A Cavalry packs in a 35x35MM size ready to blast all the power to the motors!  Easy Solder tabs. Strongest braking power. Littlebee smoothness and feel.

    Loaded with the newest 14.4 Firmware . With a New IC driver, this esc is one of the fastest and strongest. The new generation of high-quality IC and F330 Silabs chip imports to make smaller, lighter. With a triple IC drive everything including braking is more sensitive and rapid. Great support for 4S Batteries , making it perfect for racing. active-wheeling technology for a more efficient and quicker throttle response. Twisted pair copper wires to reduce interference signals generated within the transmission,MORE Thrust! HIGHER Top-end Endurance! BETTER Motor Efficiency! FASTER Responsive Time

     

    Bootloader: BlHeli
    Processor: SiLabs F330
    UBEC: N/A
    Lipo Supported : 2 to 4 cells
    Processor: SiLabs F330
    Bootloader: BlHeli (FC pass-throught)
    Firmware: LittleBee 20A
    Servo Cable Flashable - One-Wire-Interface
    BlHeli: Dampend light enabled and OneShot42 compatible
    BlHeli:OneShot125 AutoDecect
    BEC: None
    Naked
    35mm x 35mm x 5mm
    Newest, Strongest, IC driver
    Tons of Power!
    New Dedicated fast switching gate driver

     

    Learn More
  4. $25.00
    View Details

    RTF Mini "4-in-1" 12-Amp 35x35 

    Users will need to install cap and wires. 

     

    Please note: This is for more advanced users. Good soldering is a must.

    Watch your spacer size, the clearance is minimal. 3mm spacers work best, but you still need to file down the thick edges.

    5-15-13 simonk firmware installed. 

    Learn More
  5. $25.00
    View Details

    RTF Mini "4-in-1" 12-Amp 35x35 HIGH VOLTAGE up to 4s

    RTF  "4-in1" 12 amp ESC with customized SimonK firmware including OneShot auto-detect is the perfect ESC to use on any MultiCopters. This ESC is small in size (35mmX35mmx6mm) and big on power, supporting 22A on 4s , testing up to 250watts per channel . The ESC comes pre-loaded with the newest simonk  firmware, which is compatible with new features like "OneShot" (no soldering required, it will auto-detect if OneShot is enabled), Comp PWM (similar to KISS braking feature), compatible withanymost all  motors up to 4 cell.

    The RTF 12 amp AutoShot 4-in1 ESC has been tested and are compatible with all RTF motors , 2S-4S, both 5" and 6" props without sync loss issues or cogging.

    Users will need to install and wires. no extra cap needed

    Please note: This is for more advanced users. Good soldering is a must.

    Watch your spacer size, the clearance is minimal. 3mm spacers work best, but you still need to file down the thick edges.

     

    Learn More
  6. $25.00
    View Details

    NOW WITH BLHeli Boot-loader! Update settings easy with 1 wire interface!

    Flashed with newest BlHeli 14.4 firmware installed and tested! RTF 12A  BL-Heli '4-in-1" ESC are made for any MultiCopter - specifically to run at 2s,3S or 4S they also feature ultra light weight  gram construction with excellent thermal properties. - the MOSFETS are specifically selected to run BL-Heli WITH active damping code with the least amount of heat production and highest efficiency. This is opposite to the majority of ESCs retrofitted with SimonK or BL-Heli which actually run much hotter and are less efficient - We have selected very carefully the BEST mosfets to run on BLHEli code - These ESC are perfect for 3S or 4S pro-spec Quads. These ESC have OneShot enabled auto-detected code installed. - Damped Light Mode and Oneshot capable.

    RTF Mini "4-in-1" 12-Amp 35x35 HIGH VOLTAGE up to 4s- Damped Light Mode and Oneshot capable.

    Users will need to install and wires. no extra cap needed

    Please note: This is for more advanced users. Good soldering is a must. Watch to make sure the solder does not overflow to the mosfets.

    Watch your spacer size, the clearance is minimal. 3mm spacers work best, but you may still need to file down the thick edges.

     

    Learn More

Grid List

Set Descending Direction

11-16 of 16

Page:
  1. 1
  2. 2