Please expect some delay in testing for July 2021.All flight controllers flashed and tested with newest firmwre before shipping, Departing from Florida, U.S.A.  

uSKY Frsky Nano Receiver

uSKY Frsky Nano Receiver
$6.99
$6.99
 
Description

Details

The uSky nano receiver is the worlds smallest and lightest FrSky compatible full telemetry receiver, measuring at just 11.2mm x 8.51mm and weighing 0.37g. This is from the designer of the TinyFish, Simon and is published as a uSKY open source project uSKY nano FrSky receiver of revolutionary tiny 11.2mm x 8.51mm size which weights only 0.37g will take your mini/micro FPV racing drone to the next level of miniaturization.

antenna length is correct = 31.5mm long (1/4 wavelength at 2.4GHz) 

NOTE: The signal cables comes to the "bind" pad. after your bound. Please change the wire to the PPM/SBus pad (see pictures)

For ease of use the RX will come with power and signal wires.  to bind connect the signal and ground wires 

  • 11x9mm at 0.4g so it's absolutely tiny and light.
  • Runs completely open source firmware (hardware is also open source)
  • SBUS output (only runs in D8 mode for now so not compatible with EU LBT firmware)
  • Runs at 3.3V (so watch out for this because most FC have 5V supply for ESC)
  • Specifications:
  • Voltage: 3.3V
  • Output: SBUS
  • Weight: 0.37g
  • Size: 11.2 x 8.51mm
  • Compatibility: Frsky D8 X9D Plus (installed and loaded)

All credits tp Pepperfish :  http://fishpepper.de/projects/usky/

https://github.com/fishpepper/opensky

 transmitter setup – use D8 mode

Ports -> enable Serial Rx on UART3

*Save and Reboot

Configuration->Receiver section->Mode=Serial-based receiver. Provider=SBUS

*Save and Reboot

Receiver->Channel Map change to TAER1234

*Save

in CLI run “set sbus_inversion = OFF” then run “save”

Reviews